The ‘A’ in A-Line apparently stands for Anger. So far, this has been my least favorite project.

I made this skirt as part of a Sewing Basics II class, which was offered by the Philadelphia Sewing Collective. The instructor was Christine Phillips, a local fashion designer. The fabric was purchased at Spool.

On the hanger, it looks like a typical A-Line skirt; nondescript and nothing obviously wrong with it.

But, underneath, lurks a disfigured monster that I am now referring to as…

Franken-skirt!

Everything started out well, but, after the whole thing was put together (of course), I realized that it was about 5″ too small in the hips. I had to add fabric inserts on both sides to make it fit. I started out with tapered inserts, but, the skirt kept puckering, so I had to go with straight inserts.

I am still extremely confused by how it could have been that small. According to the pattern (Simplicity #4036), the hips were just one inch smaller than the A-Line skirt from Betsy Ross Patterns. If the measurements were accurate, it should have fit perfectly, because I have a little bit of room in the Betsy Ross skirt. I can understand sizes being different (i.e., a size 10 in one brand, is different than a size 10 in another brand) but, in this case, we’re talking about standardized units of measurement (specifically, inches), so I’m not sure how they can be that far off.

I’m inclined to believe that Simplicity is the problem, rather than Betsy Ross, since another pattern I bought from Simplicity created a garment that was way too big. Although, after re-reading my last post, where I thought the Betsy Ross skirt was going to be 5″ too small, maybe I’m just inclined to give Betsy Ross the benefit of the doubt, since the skirt I made from their pattern actually fit.

The inserts weren’t long enough.

I felt like I needed to rush to get the inserts completed during class, since I needed help from the instructor. Consequently, they wound up being too short. It wasn’t the end of the world, but now my hem looks weird.

Adding inserts also made the waistband too short.

After installing the inserts, I had to make the waistband longer. I measured the skirt, and factored in enough fabric for the seam allowances, as well as a little bit of extra at the zipper. Unfortunately, it still wound up being about 3/4″ too short. As you can see in the above picture, I had to pull a Frankenstein at the end of the waistband, otherwise, it wouldn’t have attached properly to the zipper.

Although a lot went wrong, some things also went right…

I was able to install another zipper.

And, I got to practice some more darts.

Overall, I guess the skirt looks fine from the outside, which is one of the great things about sewing. However, the inserts have made the skirt too wide at the bottom, so I’ll probably still have to take it to the dry cleaner for tailoring. That sort of defeats the purpose, doesn’t it?